If you have a fire or water emergency, please call us now at (651) 705-7028

To have the optimal experience while using this site, you will need to update your browser. You may want to try one of the following alternatives:

Fire & Water - Cleanup & Restoration

Ice Dam Prevention

1/19/2021 (Permalink)

Icicles in sun light Stopping ice dams is simple, in principle.

Here’s how to prevent ice dams in 8 steps so you can enjoy a winter free of icicles and the damage they can do to your roof.

Dam Busters

Stopping ice dams is simple, in principle: Just keep the entire roof the same temperature as the eaves. You do that by increasing ventilation, adding insulation, and sealing off every possible air leak that might warm the underside of the roof, as shown in the illustration below. By taking care of these trouble spots, listed here in order of priority, you should enjoy a winter free of dams and use less energy to boot.

  1. Ventilate Eaves and Ridge

A ridge vent paired with continuous soffit vents circulates cold air under the entire roof. Both ridge and soffit vents should have the same size openings and provide at least 1 square foot of opening for every 300 square feet of attic floor. Place baffles at the eaves to maintain a clear path for the airflow from the soffit vents.

  1. Cap the Hatch

An unsealed attic hatch or whole-house fan is a massive opening for heat to escape. Cover them with weather-stripped caps made from foil-faced foam board held together with aluminum tape.

  1. Exhaust to the Outside

Make sure that the ducts connected to the kitchen, bathroom, and dryer vents all lead outdoors through either the roof or walls, but never through the soffit.

  1. Add Insulation

More insulation on the attic floor keeps the heat where it belongs. To find how much insulation your attic needs, check with your local building department.

  1. Install Sealed Can Lights

Old-style recessed lights give off great plumes of heat and can't be insulated without creating a fire hazard. Replace them with sealed "IC" fixtures, which can be covered with insulation.

  1. Flash Around Chimneys

Bridge the gap between chimney and house framing with L-shaped steel flashing held in place with unbroken beads of a fire-stop sealant. Using canned spray foam or insulation isn't fire safe.

  1. Seal and Insulate Ducts

Spread fiber-reinforced mastic on the joints of HVAC ducts and exhaust ducts. Cover them entirely with R-5 or R-6 foil-faced fiberglass.

  1. Caulk Penetrations

Seal around electrical cables and vent pipes with a fire-stop sealant. Also, look for any spots where light shines up from below or the insulation is stained black by the dirt from passing air.

Other News

View Recent Posts